Результаты исследований: Вклад в журнал › Статья › Рецензирование
Результаты исследований: Вклад в журнал › Статья › Рецензирование
}
TY - JOUR
T1 - INVESTIGATION OF FORCE PARAMETERS DURING ROLLING IN RELIEF ROLLS
AU - Esbolat, Aibol
AU - Panin, Evgeniy A.
AU - Arbuz, A.
AU - Kuis, Dmitry
AU - Naizabekov, Abdrakhman
AU - Lezhnev, S.
AU - Yerzhanov, Almas
AU - Krupenkin, Ivan
AU - Tolkushkin, A.
AU - Kawalek, Anna
AU - Voroshilov, Denis S.
N1 - This research was funded by the Science Committee of the Ministry of Education and Science of the Republic of Kazakhstan (Grant № AP14869080).
PY - 2023/5
Y1 - 2023/5
N2 - The paper presents the results of theoretical studies of the force parameters of thick-sheet blanks rolling in relief rolls. Empirical dependences were obtained to determine the average rolling pressure and force. When studying the pressure, the approach of replacing the deformation scheme with a flat analog was used. In the analysis of the force, the finite element method was used to determine the geometric parameters of the deformation zone. Verification of the obtained dependencies was carried out by comparison with the results of computer simulation. Comparative analysis showed high convergence of the calculation and simulation results, as well as the possibility of applying the formulas obtained not only for symmetrical rolling or for speed asymmetry, but also in the case of rolling in relief rolls of different diameters. © 2023, Journal of Chemical Technology and Metallurgy. All Rights Reserved.
AB - The paper presents the results of theoretical studies of the force parameters of thick-sheet blanks rolling in relief rolls. Empirical dependences were obtained to determine the average rolling pressure and force. When studying the pressure, the approach of replacing the deformation scheme with a flat analog was used. In the analysis of the force, the finite element method was used to determine the geometric parameters of the deformation zone. Verification of the obtained dependencies was carried out by comparison with the results of computer simulation. Comparative analysis showed high convergence of the calculation and simulation results, as well as the possibility of applying the formulas obtained not only for symmetrical rolling or for speed asymmetry, but also in the case of rolling in relief rolls of different diameters. © 2023, Journal of Chemical Technology and Metallurgy. All Rights Reserved.
UR - http://www.scopus.com/inward/record.url?partnerID=8YFLogxK&scp=85164586057
M3 - Article
VL - 58
SP - 961
EP - 968
JO - Journal of Chemical Technology and Metallurgy
JF - Journal of Chemical Technology and Metallurgy
SN - 1314-7471
IS - 5
ER -
ID: 41996591