In the original publication [1], four references were not cited. These citations as references [225–228] have now been inserted into the caption in Figure 5 and should read as follows: Figure 5. Schemes of methods used to apply electrode layers: (a) slurry application; (b) spraying; (c) screen printing; (d) film casting ((a) is reproduced from [225] with permission of IOP Publishing; (b) is reproduced from [226] with permission of Taylor and Francis; (c) is reproduced from [227]; (d) is reproduced from [228] with permission of J. Wiley and Sons). 225. Ahamad, S.; Ahmad, M.; Mehta, B.R.; Gupta, A. Effect of Nano-Fillers on Capacity Retention and Rate Capability of Mesocarbon Microbeads Anode. J. Electrochem. Soc. 2017, 164, A2967–A2976. https://doi.org/10.1149/2.0351713jes. 226. Verma, R.; Suri, N.M.; Kant, S. Effect of Parameters on Adhesion Strength for Slurry Spray Coating Technique. Mater. Manufact. Proc. 2017, 32, 416–424. https://doi.org/10.1080/10426914.2016.1221090. 227. Creanga, C.; Serban, S.; Pittson, R.; Murr, N.E. “No Calibration” Type Sensor in Routine Amperometric Bio-sensing: An Example of a Disposable Hydrogen Peroxide Biosensor. In Biosensors—Emerging Materials and Applications; InTechOpen: London, UK, 2011; pp. 141–152. https://doi.org/10.5772/17769. 228. Ren, L.; Luo, X.; Zhou, H. The Tape Casting Process for Manufacturing Low-temperature Co-fired Ceramic Green Sheets: A Review. J. Am. Ceram. Soc. 2018, 101, 3874–3889. https://doi.org/10.1111/jace.15694. References [225–460] in the original publication would be updated to [229–464] accordingly. The authors state that the scientific conclusions are unaffected. This correction was approved by the Academic Editor. The original publication has also been updated.