Standard

Atomic Ordering Kinetics in a Cu–56 at % Au Alloy at a Temperature of 250°C. / Volkov, A.; Podgorbunskaya, P.; Novikova, O. et al.
In: Inorganic Materials, Vol. 59, No. 6, 01.06.2023, p. 563-569.

Research output: Contribution to journal › Article › peer-review

Harvard

Volkov, A, Podgorbunskaya, P, Novikova, O, Valiullin, A, Glukhov, A & Kruglikov, N 2023, 'Atomic Ordering Kinetics in a Cu–56 at % Au Alloy at a Temperature of 250°C', Inorganic Materials, vol. 59, no. 6, pp. 563-569. https://doi.org/10.1134/S0020168523060171

APA

Volkov, A., Podgorbunskaya, P., Novikova, O., Valiullin, A., Glukhov, A., & Kruglikov, N. (2023). Atomic Ordering Kinetics in a Cu–56 at % Au Alloy at a Temperature of 250°C. Inorganic Materials, 59(6), 563-569. https://doi.org/10.1134/S0020168523060171

Vancouver

Volkov A, Podgorbunskaya P, Novikova O, Valiullin A, Glukhov A, Kruglikov N. Atomic Ordering Kinetics in a Cu–56 at % Au Alloy at a Temperature of 250°C. Inorganic Materials. 2023 Jun 1;59(6):563-569. doi: 10.1134/S0020168523060171

Author

Volkov, A. ; Podgorbunskaya, P. ; Novikova, O. et al. / Atomic Ordering Kinetics in a Cu–56 at % Au Alloy at a Temperature of 250°C. In: Inorganic Materials. 2023 ; Vol. 59, No. 6. pp. 563-569.

BibTeX

@article{24d714ed8146497f9964247162966975,
title = "Atomic Ordering Kinetics in a Cu–56 at % Au Alloy at a Temperature of 250°C",
abstract = "We have studied the kinetics of the disorder → order (A1 → L10) transformation in Cu–56Au nonstoichiometric alloy at a temperature of 250°C. The disordered initial state of the alloy was produced by either quenching of samples from a high temperature or plastic deformation. The results demonstrate that the rate of atomic ordering in the quenched alloy is extremely low: the transformation needs approximately two months of annealing at a temperature of 250°C to reach completion. The rate of atomic ordering in predeformed samples is even lower. In both an as-quenched and an ordered state, the lattice parameters of the alloy under investigation slightly exceed those of the equiatomic alloy. Independent of the initial state of samples, their microhardness first rises in the course of atomic ordering and then falls off. The resistivity of Cu–56Au alloy in a well-ordered state has been shown for the first time to be ρ = 7.04 × 10–8 Ω m, which is far lower than was thought previously. The data we obtained have been used to assess the ratio of the phases present (order/disorder) in different stages of annealing.",
author = "A. Volkov and P. Podgorbunskaya and O. Novikova and A. Valiullin and A. Glukhov and N. Kruglikov",
note = "This work was supported by the Russian Science Foundation, project no. 21-13-00135.",
year = "2023",
month = jun,
day = "1",
doi = "10.1134/S0020168523060171",
language = "English",
volume = "59",
pages = "563--569",
journal = "Inorganic Materials",
issn = "0020-1685",
publisher = "Maik Nauka-Interperiodica Publishing",
number = "6",

}

RIS

TY - JOUR

T1 - Atomic Ordering Kinetics in a Cu–56 at % Au Alloy at a Temperature of 250°C

AU - Volkov, A.

AU - Podgorbunskaya, P.

AU - Novikova, O.

AU - Valiullin, A.

AU - Glukhov, A.

AU - Kruglikov, N.

N1 - This work was supported by the Russian Science Foundation, project no. 21-13-00135.

PY - 2023/6/1

Y1 - 2023/6/1

N2 - We have studied the kinetics of the disorder → order (A1 → L10) transformation in Cu–56Au nonstoichiometric alloy at a temperature of 250°C. The disordered initial state of the alloy was produced by either quenching of samples from a high temperature or plastic deformation. The results demonstrate that the rate of atomic ordering in the quenched alloy is extremely low: the transformation needs approximately two months of annealing at a temperature of 250°C to reach completion. The rate of atomic ordering in predeformed samples is even lower. In both an as-quenched and an ordered state, the lattice parameters of the alloy under investigation slightly exceed those of the equiatomic alloy. Independent of the initial state of samples, their microhardness first rises in the course of atomic ordering and then falls off. The resistivity of Cu–56Au alloy in a well-ordered state has been shown for the first time to be ρ = 7.04 × 10–8 Ω m, which is far lower than was thought previously. The data we obtained have been used to assess the ratio of the phases present (order/disorder) in different stages of annealing.

AB - We have studied the kinetics of the disorder → order (A1 → L10) transformation in Cu–56Au nonstoichiometric alloy at a temperature of 250°C. The disordered initial state of the alloy was produced by either quenching of samples from a high temperature or plastic deformation. The results demonstrate that the rate of atomic ordering in the quenched alloy is extremely low: the transformation needs approximately two months of annealing at a temperature of 250°C to reach completion. The rate of atomic ordering in predeformed samples is even lower. In both an as-quenched and an ordered state, the lattice parameters of the alloy under investigation slightly exceed those of the equiatomic alloy. Independent of the initial state of samples, their microhardness first rises in the course of atomic ordering and then falls off. The resistivity of Cu–56Au alloy in a well-ordered state has been shown for the first time to be ρ = 7.04 × 10–8 Ω m, which is far lower than was thought previously. The data we obtained have been used to assess the ratio of the phases present (order/disorder) in different stages of annealing.

UR - http://www.scopus.com/inward/record.url?partnerID=8YFLogxK&scp=85174960654

UR - https://gateway.webofknowledge.com/gateway/Gateway.cgi?GWVersion=2&SrcAuth=tsmetrics&SrcApp=tsm_test&DestApp=WOS_CPL&DestLinkType=FullRecord&KeyUT=001130623400013

U2 - 10.1134/S0020168523060171

DO - 10.1134/S0020168523060171

M3 - Article

VL - 59

SP - 563

EP - 569

JO - Inorganic Materials

JF - Inorganic Materials

SN - 0020-1685

IS - 6

ER -

ID: 50623363