An important aspect in the production of geodetic equipment is the control and measurement of parts of the entire unit. The problem of choosing the method for controlling the geometric dimensions of parts in the production of geodesic products is raised. Simple analysis and further choice of control method do not give a clear answer which method will best suit the requirements of a particular production unit and technological process. The researchers developed an algorithm for selecting a method for controlling the geometric dimensions of parts, consisting of 6 steps. For approbation of the proposed method of analysis control and measuring operations necessary according to technological maps in the production of electronic total stations were considered. The advantages of the algorithm presented are the consideration of the maximum number of parameters in the analysis, taking into account both technical and organizational factors. This method can be used for any object when changing the analysis parameters. The study tested the algorithm for the analysis of the most popular control methods. The first three steps of the algorithm require the formation of an expert commission, which can add subjectivity to the evaluation of the parameters of the analysis. The final steps of the control method selection algorithm are calculated. The result of the proposed method is the calculation of a weighted parametric index.